Lightening cuts and Parkers Found?

[Bindlestiff]

yep

[Austin W Hogan]

Check with Jim K; I think his early 20 may have milled grooves in both water table and fore end iron; my similar 17448 does.

Best, Austin

[Travis Newman]

I have 14290 and they are just in the water table.

[Jim Kucaba]

Originally Posted by Austin W Hogan

Check with Jim K; I think his early 20 may have milled grooves in both water table and fore end iron; my similar 17448 does.

Best, Austin

My 20ga lifter gun is Serial Number 10165 and it does have lightening slots milled into the water table but not in the fore end iron.

Jim Kucaba ... AriZOOna Cactus Patch ... Email: JimKucaba@aol.com

[Austin W Hogan]

The cut is on the underside of the fore end iron, covered by the splinter

Best, Austin

[C.O.B.]

Number 13011 is a 16ga Lifter with the lightening cuts in the watertable. I'm not takeing the forend iron off to look there

[Opening Day]

Originally Posted by Richard Anderson

Number 13011 is a 16ga Lifter with the lightening cuts in the watertable. I'm not takeing the forend iron off to look there

Good Boy Rich as you know you are not allowed to play with screwdrivers.... Eric