Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
Has anyone had any good success with replacing the Joint Roll (the round washer piece that goes over the hinge pin)? I am curious if they require a lot of fitting. Also, if you have a gun that is off face and you replace the Joint Roll, can this make the gun tight? I have heard that it can go both ways, i.e. sometimes the gun is looser. Finally on extractor guns is the Joint Roll the same size for all frame sizes?
Re-Jointing
Threaded Mode