12 GA barrels

Alton Anker · 03-02-2015, 10:46 PM

Good evening to all
I have a question on two sets of Parker repo barrels the barrels are stamped
Imp cyl and mod on both sets but when I measure them on the right barrel the restriction is six thousands and the left barrel measures twelve thousands restriction that would tell me they are choked skeet and ic what am I missing both sets measure very close to the same that would lead me to believe they have not been tampered with thanks in advance to set me stright
Alton Anker

Bob Jurewicz · 03-03-2015, 06:33 AM

Alton,
I have measured a few Repro 12s and those are factory specs. I made a post of Repro Choke Measurements in this Forum Topic a couple years ago.
Bob Jurewicz

Alton Anker · 03-03-2015, 09:15 AM

Thank you Bob
So do think I have skeet and IC or do I have IC and mod like the barrels suggest
Or do I try to compare to a modified choke on the pattern board ?...
Thanks for the help
Alton

Dean Romig · 03-03-2015, 10:09 AM

Those chokes are pretty open for what they are marked and sound more like Skeet out and Skeet in. I would suggest patterning the gun and if they pattern at 50% and 65% it would seem the barrels should have been stamped Q1 & Q2.

Respecting what Bob said as those being factory spec... patterning will tell you what you have.

Bob Jurewicz · 03-03-2015, 11:22 AM

http://parkerguns.org/forums/showthr...ighlight=choke
Bob Jurewicz