Barrel lug repairs.

B. Dudley · 12-08-2014, 06:58 PM

I was looking at a very early high grade Parker today. In the 4,000 serial number range. There is records to suggest that the gun went back to the factory at a point in its life, but cannot tell what for.

The barrels show evidence of some work possibly being done. Along with some tightening work to the barrel lug.

It has a piece pinned and soldered onto the hook. The solder has since popped free, But the pin still holds the piece in place with a little movement. I know that this type of repair has been seen on some older Parker guns and discussed here before.
However, there is another repair that I found when looking closely that was new to my eyes at least. There is a piece dovetailed and soldered in place at the back of the locking lug. This is the surface that bears against the "bridge" in the water table slot.
See photos below.

image.jpg

B. Dudley · 12-08-2014, 06:59 PM

image.jpg

B. Dudley · 12-08-2014, 07:00 PM

image.jpg

OH Osthaus · 12-08-2014, 07:03 PM

some one did some fine file work there

Dean Romig · 12-08-2014, 07:23 PM

We've seen mortised ("dove-tailed") repairs on a few Parkers before, including at least one (that I have seen) mortised hook repair.

And yes, Austin featured a hook repair, like the one you show, a few years ago in Parker Pages.

Angel Cruz Ortiz · 12-08-2014, 09:06 PM

Why would that need to be repaired at that particular spot? How much stress can be there from the recoil? I'm looking at my lifter and I just can't see that spot breaking.

John Taddeo · 12-08-2014, 10:36 PM

One would think Parker would just replace and refit a new set barrels ...

Bill Murphy · 12-09-2014, 11:32 AM

Some very respected gunsmiths like to dovetail a new piece at the hook and refile the curve. I think its a lot of wasted effort and expense, when a nearly invisible shim can be put in place.

Dean Romig · 12-09-2014, 11:41 AM

A "nearly invisible shim" is not a repair but merely a 'band-aid'.

Dean Romig · 12-09-2014, 11:44 AM

Quote:

Originally Posted by John Taddeo

One would think Parker would just replace and refit a new set barrels ...

At half the price of a new gun, replacing the complete set of barrels should be a last resort unless the owner of the gun had ordered it done.