Cross Hatch on the Water table

Dennis · 01-08-2014, 05:15 PM

Recently a member posted a photo of a Parker lifter that had cross hatching on the water table. I had not seen that before and am wondering if that was something from the Parker factory or an after market addition. Does anyone know the reason for doing that other than decorative?

Dennis

OH Osthaus · 01-08-2014, 05:24 PM

I would expect it was aftermarket, sort of like engine turning - both decorative and many believe it holds oil better.

Bill Murphy · 01-08-2014, 05:45 PM

Extremely early Parker hammerless guns were crosshatched at the factory. I would expect that any Parker with well done crosshatching should be considered "factory" unless something else about the gun sends a negative signal. Since the water table is not a moving part, I assume the crosshatching in that area is decorative.

OH Osthaus · 01-08-2014, 06:51 PM

Quote:

Originally Posted by Bill Murphy

Extremely early Parker hammerless guns were crosshatched at the factory. .

like this?

Dennis · 01-08-2014, 05:48 PM

Thanks for the information. Of course it is hard to say but it did look like factory work in the photo.

Dennis

Jeff K. · 01-08-2014, 06:58 PM

I believe that Austin wrote an article on cross hatching for the Parker Pages. I don't remember the volume.

Autumn Daze · 01-08-2014, 07:47 PM

Cross hatching is a great way to help oil retention.

B. Dudley · 01-08-2014, 10:33 PM

I have seen it before and it could be factory. Of course, a particular one being looked at could also be an addition.
Another thing that Parker did was a kind of sunburst pattern on the breech face of barrels. It is not often seen on guns other than ones in higher original condition.

image.jpg

Dean Romig · 01-08-2014, 11:14 PM

Quote:

Originally Posted by Brian Dudley

I have seen it before and it could be factory. Of course, a particular one being looked at could also be an addition.
Another thing that Parker did was a kind of sunburst pattern on the breech face of barrels. It is not often seen on guns other than ones in higher original condition.

Attachment 29889

Or where it has been applied on a set of barrels to make them appear to be in higher "original" condition.

B. Dudley · 01-08-2014, 11:28 PM

Quote:

Originally Posted by Dean Romig

Or where it has been applied on a set of barrels to make them appear to be in higher "original" condition.

True Dean.
I have heard that can be replicated with a business card edge and a lapping compound.