|
03-02-2016, 08:24 PM | #3 | ||||||
|
I know I've seen it somewhere on this forum... Is there a conversion table for frame size and distance between the firing pins?
Still curious what the "F" represents. I thought I read something about early Repros being stamped incorrectly based on wrong information translated from an original, the mistake was caught and corrected? I can't remember the article I read that in and cannot find it now.
__________________
"The road was long, but he knew where he was going..." ~Corey Ford, The Road to Tinkhamtown |
||||||
03-02-2016, 09:20 PM | #4 | ||||||
|
In regards to the "F" and "I" stamped on the barrel lugs go here and pay particular attention to Richard Skeuse's response:
http://parkerguns.org/forums/showthread.php?t=5012 In regards to Parker frame sizes go to the PGCA Home page. In the left hand margin click on "Technical Information", a new page comes up, then click on "Frame Sizes by Gauge", the chart contains the info you're looking for.
__________________
Wild Skies Since 1951 |
||||||
03-02-2016, 09:29 PM | #5 | ||||||
|
Greg, thank you! My 28 is marked identically to the pictures in that thread. This helps me clear that up. Thanks for navigating me to the technical info link too. I knew someone here would have answers for me. This is a fantastic resource and a great group of folks!
__________________
"The road was long, but he knew where he was going..." ~Corey Ford, The Road to Tinkhamtown |
||||||
|
|