Tongue in cheek question about working on my Parker - Page 2

Chaz Doebler · 07-12-2013, 12:58 PM

So for those of you scoring at home;
Lowered the comb, shortened the stock (fixed pitch)
Installed butt plate
Replaced hammers, sears and triggers

"Percy"

It still needs a few more coats of oil as there are some dull spots. I could probably reblue the barrels yet, but it is so much easier not to, rust boil, rust boil, rust boil....

edgarspencer · 07-12-2013, 02:29 PM

Nicest piece of wood I've seen on a Trojan yet. Barrels look fine from what I can see.

charlie cleveland · 07-12-2013, 07:44 PM

fine lookin gun for a home spun gun dont figure you would have no trouble finding work..this is truly nice work....charlie

Chaz Doebler · 07-12-2013, 10:32 PM

I can't take too much credit for this one as it was restocked when I got it. I just adjusted it to fit me (the comb was really high), and replaced some internals to make it work again. Special thanks to Mr. Dudley for supplying all the parts I needed.

I just weighed it tonight with the stock work done and it is 8 pounds 1 ounce and change. With 30 inch barrels choked imp cyl/mod it should be great for sporting clays. I will find out tomorrow.

CHAZ