Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
Mills, Don't write the barrels off if there is a slight bulged at the forcing cone. I have gun I was lucky with, which had precisely the same bulge, and I was able to 'tap it back down using a piece of think brass stock (.5" x 1") and a small ball peen hammer. I slowly worked the bulge right back to where the barrels were when they left the factory. I did make a mandrel to insert in the bore before I began.
Hybrid Mode