Chuck,
That's a heck of a contraption you have built there. Looks like it provides excellent control of the process. I did not note that my gun was bent back to neutral cast when I acquired it. Mike Orlen did the job and did it well IMO. he probably took out 3/8" and stabilized a small check in the grain near the back end of the top tang. I wish I had discussed a second bend to bring it down just a bit while I had it with him as this may have influenced how to deal with the check.. I would like to get it to 2 1/2 and maybe a little cast off so I can get really dialed in with it as it's a very functional 2 barrel set.
Regards,
Jerry
|
Threaded Mode