Stock Removal

[Paul Harm]

Hammer guns - I'm going by memory. The locks are held in by one screw going from one lock to the other. On top levers it's right behind the hammer. There's also a small tang on the front of the lock that you can't see that's inletted into the receiver. Loosen the screw a couple of turns and tap it with the back of the srcew driver or plastic hammer- this will loosen the right lock. Now turn the screw out and remove the right lock. You will see a hole going through the stock in the rear of where the lock was and in there are the top of the triggers. Useing a small drift and holding the triggers forward, push the drift through the hole till you hit the other lock. Now tap the drift to loosen the left lock. With both locks removed next remove the trigger guard screw and pull the trigger guard up and out. The two trigger plate screws can now come out. Next the big screw under the top lever can be loosen a turn or two and tapped down flush to loosen the trigger plate. Take the screw out and now the trigger plate should come out. The stock can now be removed. Hope this helps and others may chime in.