Parts blueprints

[Robert Delk]

I need drawings that a machinist could use to make the parts from scratch.

[Double Play]

Robert,
I doubt you will have much luck finding drawings for original parts and even if you did some parts were fitted at assembly and could be somewhat different from gun to gun. I've made some roll joints for hammer and hammerless guns as well as bolt plats of the older and newer styles and would simply copy what came out of the gun while adding material were needed. I think reverse engineering in this manner is your only choice.

[Autumn Daze]

Bob,There are some pretty good drawings in the Parker Story for ejector parts. I looked quick but couldn't find them but they are there.