8 GA. Shells

[6pt-Sika]

Originally Posted by Bill Murphy

I see no reason to crimp a brass case with a ball or bullet unless you are actually carrying the gun in the field. There is no crimping with Rocky Mountain Cartridge Company cases.

If I wasn't planning on using it in the field I wouldn't load it in the first place .

And I don't know if this is actually what one would call a crimp as such . To me it sort of looks like a large torx bit .

Oh incidently if it was done before I think it's safe to assume that it CAN be done again with Rocky Mountain cases regardless of what your PERSONAL opinion may or may not be .

[Bill Murphy]

I'm sure you are correct.

[edgarspencer]

Originally Posted by CraigThompson

If I wasn't planning on using it in the field I wouldn't load it in the first place .

And I don't know if this is actually what one would call a crimp as such . To me it sort of looks like a large torx bit .

Oh incidently if it was done before I think it's safe to assume that it CAN be done again with Rocky Mountain cases regardless of what your PERSONAL opinion may or may not be .

I think you might want to speak to RMC. I seriously doubt their case is thin enough not to crack, if crimped. The loads I have seen do not have a "shotshell crimp", but just the most modest turned in edge like a rifle cartridge crimp, and they were drawn brass cases. There was also a canalure in the (Conical) bullet.

[Roundsworth]

RCBS makes a set of 12 gauge dies that applies a slight turned over crimp, similar to that used on a lead bullet handgun load. If used with a stiff overshot wad, this might be a good alternative. I have only seen this done on thin, drawn hulls, such as Magtech. Good luck!

[Bill Murphy]

I would prefer a glued in top wad in my RMC hulls. I have no interest in using black powder. Mr. Farfaro is filling a void but I think most of us would rather approach the eight gauge situation from a different direction.