Typical Rates ?

[6pt-Sika]

Originally Posted by Eric Eis

But remember this had better be a gun you want to keep because it will cost you more then what you will be able to sell the gun .

Hence my reason for asking about typical cost for such undertakings .

[Opening Day]

Originally Posted by CraigThompson

Hence my reason for asking about typical cost for such undertakings .

Craig you are looking at about $300 for the barrels, not sure what the case colors are but a minimum of $550 and up So if it's a gun that means alot to you or your family well maybe otherwise use as is or maybe just get the barrels done, they will really pop.

[6pt-Sika]

Originally Posted by Eric Eis

Craig you are looking at about $300 for the barrels, not sure what the case colors are but a minimum of $550 and up So if it's a gun that means alot to you or your family well maybe otherwise use as is or maybe just get the barrels done, they will really pop.

I only have one that I would want anything done to .

This being a little circa 1911 Parker GH 16 gauge that has about an inch to 2 inch flat on the side of the left barrel . This gun has also had the barrels cut to 27" where it's now measuring skeet and IC . The action could get by without recasing just thought it might look nice !

The toe is also gone from the buttplate , so I suppose I should have a new buttplate installed . Although it's been gone for many years as the toe has gotten slightyly radiused in the actual stock itself .