Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Fair enough! I'll just have to figure out how to test the thread and width of the screw. Can get the head diameter just fine.
- just lay the existing screw on a machinist's rule and count the number of thread turns per inch- close enough, as this is going into wood, and not drilled and tapped steel- Be glad to help you out, and welcome to the PGCA brotherhood! Lotsa good info on double guns here-