2-1/2" pitch?

[Holeshot]

makes my old yardstick and ruler look state of art.

[TARNATION !!!]

Originally Posted by David Holes

makes my old yardstick and ruler look state of art.

I still suffer "yardstickophobia", since school days. That makes me a bit younger than those who remember the "hickory stick".

Cheers,
Jack

[Old and Reliable]

Originally Posted by Jack Cronkhite

I still suffer "yardstickophobia", since school days. That makes me a bit younger than those who remember the "hickory stick".

Cheers,
Jack

Them nasty Penguins loved to smash our knuckles with rulers- Nuns- probably grew up believing all boys were bad to the bone- which, in retrospect, might have been true--

[Marc Retallack]

Francis

A framing square will only indicate the portion of the jamb that it is in contact with is plumb IF the floor is truly level. You need an appropriately sized (6'6" being the standard) level to determine if a jamb is plumb. Even then, most jambs aren't perfectly true with regards to being a perfectly straight even surface.

Cheers
Marcus

[TARNATION !!!]

So....... if all is level, plumb, square and the pitch is correctly measured, cast dac, dah, lop and even drop at cheek is the perfect fit for you and you still miss the bird, is it then the fault of the ammunition????? Is there ever a point where the fault actually lies with the shooter??? I need all the excuses out there.
Cheers,
Jack

[Old and Reliable]

Originally Posted by Jack Cronkhite

So....... if all is level, plumb, square and the pitch is correctly measured, cast dac, dah, lop and even drop at cheek is the perfect fit for you and you still miss the bird, is it then the fault of the ammunition????? Is there ever a point where the fault actually lies with the shooter??? I need all the excuses out there.
Cheers,
Jack

-- a loose nut behind the buttstock-

[Old and Reliable]

Originally Posted by Marc Retallack

Francis

A framing square will only indicate the portion of the jamb that it is in contact with is plumb IF the floor is truly level. You need an appropriately sized (6'6" being the standard) level to determine if a jamb is plumb. Even then, most jambs aren't perfectly true with regards to being a perfectly straight even surface.

Cheers
Marcus

--for truing up jambs- lotsa times the 'rough-in' and then the installation of the windows and doors (prior to the J channel and then siding crew arrive)- the jack and king studs can dry out and warp- that's why we have shims- and the old rules are right- ie: "A level never lies", and "Always use the longest level you can"-- work-- but I wanted to get the framing square and Framingham, Mass bit worked in--first think we do with the 'rookie cookies" on the H4H Vol crews- we check their tape rules, levels and squares against ours-- a framing square with a 1" wide 16" long tongue and a 2" wide 24" long blade is a true 90% at one point, you are correct about that--and common and king rafters run off the 12" mark, jack and hip rafters off the 17" mark- thanks to some Greek dude name o Pythagorean, so I hear--