![]() |
![]() |
![]() |
|||||||||||||||||||||||||||||||||||||||
|
![]() |
Thank you...will give it a try... | ![]() |
![]() |
#3 | ||||||
|
![]()
Here are some images...trying to identify the grade...it looks like a 3...
|
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
The Following 3 Users Say Thank You to GeorgeMerrill For Your Post: |
![]() |
![]() |
![]() |
#4 | ||||||
|
![]()
I have more if it helps...
|
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
#5 | ||||||
|
![]()
Yes its a grade 3 looks like a nice old gun
|
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
The Following 2 Users Say Thank You to David Holes For Your Post: |
![]() |
![]() |
![]() |
#6 | ||||||
|
![]()
Thank you. I have been told that due to the age it should not be fired and that NEVER to use today's ammo under any circumstances. Does that sound right?
|
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
#7 | |||||||
|
![]() Quote:
That demands a lot of discussion, but if the barrels can be measured for wall thiskness, dents and pitting by an EXPERT in the field of 100+ year old shotguns and is deemed safe to shoot, there are modern shells that can be used in it. Chamber pressure should be kept below 8,000 PSI and less is better. And DON'T use steel shot. .
__________________
"I'm a Setter man. Not because I think they're better than the other breeds, but because I'm a romantic - stuck on tradition - and to me, a Setter just "belongs" in the grouse picture." George King, "That's Ruff", 2010 - a timeless classic. |
|||||||
![]() |
![]() |
![]() |
![]() |
![]() |
The Following 4 Users Say Thank You to Dean Romig For Your Post: |
![]() |
![]() |
![]() |
#8 | ||||||
|
![]()
I’m screwed if that’s the case ! My #1 hammer gun was made in the early 1880’s . I’ve probably put a couple thousand of my handloads thru the gun 30 grains of SR7625 pushing 1 1/4 ounces of shot . Works nicely on clay targets and tower pheasants .
__________________
Parker’s , 6.5mm’s , Mannlicher Schoenauer’s and my family in the Philippines ! |
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
The Following 3 Users Say Thank You to CraigThompson For Your Post: |
![]() |
![]() |
![]() |
#9 | ||||||
|
![]()
Not sure if you stock has been repaired by the looks of the checkering on the cheeks there could be a repair there that the checkering was done to hide the repair; better picture of that area might help. Grade 3 guns did not normally have checkering there.
|
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
The Following User Says Thank You to Steve Huffman For Your Post: |
![]() |
![]() |
![]() |
#10 | ||||||
|
![]()
George,
You have a very beautiful Parker. The "D" grades were often referred to as "Doctors" guns. The book indicates it came with 30" barrels. You have received sound advice on determining its shoot ability. I on the other hand have not had any of my Damascus and Twist Parkers barrel wall thickness checked. My thought is this, if the barrels appear not to have been tampered with they pass my test. I have two Parkers from 1881 with Twist Steel barrels. The 10 gauge I reload for. The 12 gauge and all other twist and Damascus 12 gauge shoot reloads or any off the shelf shotgun shells that are 1 oz or less at 1180 fps or less. The following are some of my choices: Federal Top Gun 12ga 2-3/4" 1oz #8 1180fps 25rd box, Winchester Super-Target Shotshells 12 ga 2-3/4" 1 oz 1150 fps #7.5 25/ct, and here is the one I love, Winchester AA Low Recoil/Low Noise Target Loads Shotshells 26 gram at 980 fps. They will break any target on a sporting clay range and cleanly take all small game birds. RST Shells are probably the best shells for our older guns. They are specifically tailored for appropriate pressure and shot payload. Harry |
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
The Following User Says Thank You to Harry Collins For Your Post: |
![]() |
|
|