Half of a nice Lifter

[Dean Romig]

Originally Posted by Bret Adams

Thanks Jim. That was a 12ga, but the iron might be made to work?

That depends on the frame size.

10’s were normally made on the 3-frame but a few were made on the 2-frame. 12 gauge Lifters were normally made on either the 1-frame or the 2.





.

[Pa SxS]

What is the S/N?

[Bret Adams]

Originally Posted by Dean Romig

That depends on the frame size.

10’s were normally made on the 3-frame but a few were made on the 2-frame. 12 gauge Lifters were normally made on either the 1-frame or the 2.





.

The measurements say it's a #2 frame.

[hugh rather]

Sure would be a find if that forend would work.Wood can be replaced.

[Bret Adams]

Originally Posted by Chuck Bishop

What is the S/N?

5791

[Dean Romig]

Originally Posted by Bret Adams

The measurements say it's a #2 frame.

More of a chance of finding a forend iron that will fit then.





.

[Larry the Gun Guy]

Originally Posted by Bret Adams

5791