Thanks for the info. I’m with you of the same thought if that 65 is for the chamber length or not. I forgot the barrel had a little dent in front of the muzzle on the right side when I got it. I tapped it out myself and had it inspected by a gunsmith that said it was as good as it’s gonna get. So I felt pretty good with my job on the repair. I pretty much between you and I using some common knowledge the last couple days after starting this post I’m just gonna make sure to cut all my plastic holes down and shorter than the forcing cones and move on. Also unfold an RST load to measure the hull length.
|
Threaded Mode