1 ounce 410 load

[charlie cleveland]

boy i was hoping some one else had seen the 1 ounce load...im still pretty sure ive seen one but then again..... i too have fooled around with the 410 loads..you can get the 1 ounce of shot in a 3inch shell but you cannot crimp it..you can lightly roll crimp it and it will work... the wads have to be very thin against the powder to work to be able to get 1 ounce in the in the 3 in hull...i shot these loads through a 12 ga single barrel using the savage 410 tenner insert..the old sigle barrel was choked clyinder bore.. at 30 yards would have been a dead quail on paper.. always thought a tighter choke might make the pattern tighter but it might make it worse..what do yall think.... charlie