Roberts Industries

Keavin Nelson · 09-13-2023, 11:15 AM

Very nice gun!
But,
is the case trimmer in production Randy, asking for a friend

Randy Roberts · 09-13-2023, 11:29 AM

Quote:

Originally Posted by keavin nelson

Very nice gun!
But,
is the case trimmer in production Randy, asking for a friend

Not really Keavin. I just threw one together for Craig.

6pt-Sika · 09-14-2023, 02:46 PM

I’ve got 100+ new uncut REM hulls so I decided to cut a few of them . The first was a bit short with the shims and after removing the shims it was pretty much the same . After trimming some I loaded two with the SP-10 wad and two with the BPI/Gualandi wad . Both using only red beans for displacement as I’d run out of 16 gauge 1/8” cards , found I needed eight beans with the SP-10 and nine with the BPI . Had YouTube showing Pacquiao fighting Thai 3K Battery think that was 2006 or 2007 fight .

Randy Roberts · 09-14-2023, 02:53 PM

Do you have one of the Ballistic Products Super Crown Crimpers?

6pt-Sika · 09-14-2023, 04:20 PM

Quote:

Originally Posted by Randy G Roberts

Do you have one of the Ballistic Products Super Crown Crimpers?

No I was contemplating one recently however . You mean the brass kinda sharp one correct ?

Randy Roberts · 09-14-2023, 04:23 PM

Yes Sir, I would highly recommend it. Works wonders on new hulls. It will make that crimp a lot neater and they will have less tendency to open up which my new hulls had prior to using the BP crimper.

6pt-Sika · 09-14-2023, 04:39 PM

Quote:

Originally Posted by Randy G Roberts

Yes Sir, I would highly recommend it. Works wonders on new hulls. It will make that crimp a lot neater and they will have less tendency to open up which my new hulls had prior to using the BP crimper.

I’m going to a Virginia Vintagers thing tommorrow at Central VA SC . Sadly when Brad got his land use permit the board of supervisors in that county said nothing larger than 10 gauge or I’d try my 1 1/8 ounce 10 gauge loads .