Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
No way to know for sure without knowing the bore diameter. If your gun is close to the norm for a 10 it should be around .775 which would give you roughly .036 of constriction. If it has been honed or over bored then that math is off the table, it could actually be tighter.
The Following 2 Users Say Thank You to Randy G Roberts For Your Post:
Threaded Mode