Parker Reproduction DHE 410 with 28" barrels

[MD*GSP]

Originally Posted by Richard Skeuse

The wall thickness on the breach must be very thick to move the barrels to the center of the firing pin hole and to the edges of the frame so it fits.

That's why I wondered what the weight of the gun is. There was a set of barrels from the same manufacturer listed for sale on GI some time back, but they weren't fitted to a gun.

[Richard Skeuse]

Hi guys. I have a set of 410 barrels but don’t have a small enough scale. I’ll go into the office in the next few day and let you know what they weigh.

[Bill Murphy]

Scot, where did those barrels come from? Why aren't there more out there?

[MD*GSP]

Originally Posted by Bill Murphy

Scot, where did those barrels come from? Why aren't there more out there?

No clue (Remington perhaps?). And, I have no idea what's out there. I did wonder if Wayne's gun was fitted w/the set pictured in my post but there are differences in the stamping, so apparently not.

[Wild Skies]

Originally Posted by Bill Murphy

Scot, where did those barrels come from? Why aren't there more out there?

There are more of them out there, we've discussed them a few times previously. Here's one of those previous discussions, including a pic of the stamp that stamped them: https://parkerguns.org/forums/showth...ighlight=stamp

[David Noble]

Although the stamp that Brian showed was very similar, it was not the stamp that was used on the barrels in this thread. In this picture you can see that there are differences in font size, letter shapes and spacing between the arched parts and the center part.

[Bill Murphy]

28"? Weren't the Galazan .410 barrels 28"?

[Wild Skies]

Originally Posted by Bill Murphy

28"? Weren't the Galazan .410 barrels 28"?

Yes, the Galazan .410 barrels made for Parker Reproductions were 28" long, but according to these advertisements they were only available in a 00-frame size. They were initially offered at $1895.00 per pair, then went to $3995.00 and finally $4800.00.