Quote:
Originally Posted by Dean Romig
Art touches on some very important points and gives very good advice.
I would FIRST make sure you have a good set of gunsmithing turnscrews (screwdrivers) and proceed with caution while applying firm even pressure as you try to break the screws free. Make sure the screw slots are clean and free of crud!!
My trick for a stuck in the wood trigger guard strap or tang is, after the screws are removed and the tang won't lift from the channel in the wood because of hardened 100-year-old crud, don't try to lift it or you may chip or splinter the wood...
Instead, rap the rear of the trigger guard bow firmly in in a motion that will drive it forward. It should break free pretty easily after just one or two firm raps and will lift up with no damage to the wood at all. Then rotate the trigger guard in a counter-clockwise motion. If it will not rotate freely it will need some solvent on the threaded area. Attempting to force it will only result in a bent and distorted trigger guard and they're an absolute bitch to straighten them back to the correct shape and angle... ask me how I know...
.
|
The knocking forward advice is an "a-ha!" idea. Use wood or plastic.
Dean is right about the straightening/reshaping. Not hard to do physically but it reminds me of trying to mold cooked spaghetti, if you get the idea.
Threaded Mode