Quote:
Originally Posted by edgarspencer
My idea was to lower only the internal profile of the trim die, without changing the way the die is secured in the press. The cam needs to still contact the roller on the die.
I accomplished the lowering of the internal die profile, by buying two new trim dies.
Next, I took the second new trim die, cut off the side mounted arms, and chucking it in my lathe, turned it to a diameter so as to have a sliding, interference fit inside the first, bored out trim die.
|
Edgar, great thinking you did there but I was confused by your use of the term
trim die. Perhaps I'm wrong, but should that have said
crimp die instead?
I'm prepared to be scolded in the event that I am wrong.
Threaded Mode