Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
I roll crimped a few 10 gauge with the hand tool but mine didn't do too good of a job. I got the Precision tool that goes in the drill press and now just use the hand cranker to put the crimp on the paper shells.
I was pretty impressed! I used a top wad punched out of picture framing matting paper with a 3/4" gasket punch.
The Following User Says Thank You to Cal Lego For Your Post:
Threaded Mode