Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
The only acceptable sizer that is part of a reloader is the PW 375. I haven't run brass shells through mine, but it sizes everything else OK. If you can get hold of a 375 in any gauge, all you need is one sizing die in ten gauge to do the job. You don't need the whole set of tools.
The Following User Says Thank You to Bill Murphy For Your Post:
Threaded Mode