VH Has Been Restocked

[Andy]

Very nice Mike. Is that little lock screw on the top "action" screw particular to a gun with Infallible triggers? Not sure I've seen that before.

[Mike of the Mountain]

Originally Posted by Andrew Sacco

Very nice Mike. Is that little lock screw on the top "action" screw particular to a gun with Infallible triggers? Not sure I've seen that before.

I believe it is so the action stays tight and doesn’t mess up the geometry. Those are technical terms.

[Kevin McCormack]

Originally Posted by Mike Koneski

I believe it is so the action stays tight and doesn’t mess up the geometry. Those are technical terms.

Basically correct; it prevents the shooter from "fine tuning" (e.g., re-QUALIFYING) the top tang screw head so it stays true in butt-to-muzzle alignment. Loosening or over tightening the top tang screw can produce over- or under- torque on the top & bottom tangs; the trigger plate being immediately affected by that can stress the movement and timing of the ST platform and components and produce all types of 'unpleasant" results: misfires, nonfires, and my personal favorite, doubling.

[Dean Romig]

Originally Posted by Kevin McCormack

Basically correct; it prevents the shooter from "fine tuning" (e.g., re-QUALIFYING) the top tang screw head so it stays true in butt-to-muzzle alignment. Loosening or over tightening the top tang screw can produce over- or under- torque on the top & bottom tangs; the trigger plate being immediately affected by that can stress the movement and timing of the ST platform and components and produce all types of 'unpleasant" results: misfires, nonfires, and my personal favorite, doubling.

The lower tang screw is every bit as sensitive to over or under tightening. I wonder if that one has a lock screw as well?





.