Microwelding for ejector repair

[Stan Hoover]

Originally Posted by Brian Dudley

Stan,
I think that what your screws are most lacking are the light cuts that go in the same direction of the screw slots. That is done with a fine comb. It looks like the edges of the slot may have just been peened down to clean them up some which lightened the comb engraving.

Brian,

This a picture of a NIB NID, I believe I understand now the light cuts you’re referring to.

[Mike of the Mountain]

Stan, I would have liked to help you out with your question but I am not very familiar with a comb.