Parker Gun Collectors Association Forums  

Go Back   Parker Gun Collectors Association Forums Parker Forums Parker Hammer Guns

Notices

Reply
 
Thread Tools Display Modes
Unread 12-23-2021, 11:19 AM   #1
Member
Dean Romig
PGCA Invincible
Life Member
 
Dean Romig's Avatar

Member Info
 
Join Date: Dec 2008
Posts: 32,957
Thanks: 38,668
Thanked 35,894 Times in 13,164 Posts

Default

My research shows that during the years that Parker-made Laminated Steel barrels were manufactured (1877-1879) and likely used in production (and for about another 3 years after the years of their production) there were 166 Grade 2 guns with L in the GRA column in the Serialization book; 37 Grade 3; 5 Grade 4; 2 Grade 5; but only 1 Grade 1 with Laminated Steel barrels.

(Caveat: We do NOT know if all of the guns in this range with the L in the GRA column were Parker-made Laminated Steel but certainly the vast majority of them very likely were. Some may have had barrels of English Laminated.)

I had thought that Grades 3 and higher were the only guns to have the Parker-made Laminated Steel barrels but in the last few years have come to believe otherwise.

Regarding the Deeley & Edge style forend latching system, (from pgs. 99-100 of The Parker Story) this new Charles A. King design was first offered in the 1878 catalog at a $5 charge on guns below Grade 3 but it became a standard feature on all grades beginning in 1880 at no extra charge. The first gun recorded with this new latching system is serial number 11631 .

Further - a quote also from pg. 100 "Some early Parker doubles have been seen with the 1878 forend latch retrofitted, undoubtedly by the factory. These have the new forend latch, the original barrel loop altered, and the hole in the forend plugged where the original key had been." (We recently saw such a forend on the forum by a member who had questions about it.) The patent date is roll-stamped on the latch lever on the lower grades but is hand-engraved on D grades and higher.

Once again I will say that The Parker Story is a most valuable resource in these discussions!!





.
__________________
"I'm a Setter man.
Not because I think they're better than the other breeds,
but because I'm a romantic - stuck on tradition - and to me, a Setter just "belongs" in the grouse picture."

George King, "That's Ruff", 2010 - a timeless classic.
Dean Romig is online now   Reply With Quote
The Following 5 Users Say Thank You to Dean Romig For Your Post:
Unread 12-23-2021, 11:50 AM   #2
Member
ArtS
PGCA Member

Member Info
 
Join Date: Nov 2021
Posts: 1,087
Thanks: 104
Thanked 1,544 Times in 572 Posts

Default

It's a shame no one kept a record (or it is lost) of the number of Parker barrels actually made. I too believe the total number was likely in the 200 range, but I do believe that a significant part of the 211 listed were imports. I can't believe that Parker used up their entire supply of imported laminates and then used almost exclusively what were expensive barrels (to them) on most of the laminate production. I would rather think that they used up their supply of imports on the lower grades in an effort to convert over to their own. It is obvious from reading the Parker Story concerning their production method that they kept a good inventory of parts in stock. So I have to presume they had an inventory on hand when the Parker laminates became available. That would put the real number less than the 211. However, there are multiple occurances of Damascus graded guns that were sold as such with Parker laminated barrels. Counting Mike's gun and the one I bought recently. I have found records of 7 or eight in the last couple of months just by reading old posts here. All but one I found mentioned are Grade 3 or above. That is a significant number compared to the actual L graded guns reported in the records. This would add to the presumed numbers.

Whatever the true number, it is a small number.
Arthur Shaffer is offline   Reply With Quote
The Following 3 Users Say Thank You to Arthur Shaffer For Your Post:
Laminated Barrels
Unread 12-23-2021, 12:20 PM   #3
Member
Stan Hoover
PGCA Lifetime
Member
 
Stan Hoover's Avatar

Member Info
 
Join Date: Sep 2019
Posts: 1,149
Thanks: 2,776
Thanked 3,121 Times in 832 Posts

Default Laminated Barrels

Does the rib legend signify if it was imported Laminated steel or Parker's own laminated Steel? Or how is the difference decided?
Stan Hoover is offline   Reply With Quote
The Following User Says Thank You to Stan Hoover For Your Post:
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 08:15 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2025, Parkerguns.org
Copyright © 2004 Design par Megatekno
- 2008 style update 3.7 avec l'autorisation de son auteur par Stradfred.