Leaded 410 barrels help needed

[Matt Buckley]

You might try a chunk of frontier pad wrapped around a .410 brush and powered by a cordless drill. A soaking of Hoppes benchrest solution, gunzilla, or ballistol and then a polishing with the frontier pad on the brush should clean up the bores pretty well.

[Dean Romig]

Originally Posted by Matt Buckley

You might try a chunk of frontier pad wrapped around a .410 brush and powered by a cordless drill. A soaking of Hoppes benchrest solution, gunzilla, or ballistol and then a polishing with the frontier pad on the brush should clean up the bores pretty well.

My recommendation is exactly like Matt’s except don’t use a solvent. You don’t want to lubricate or protect the lead. The Frontier pad will not damage the bore at all but used dry it will make short work of the lead. Do it muzzle down over a sheet of white paper and watch the little pile of lead particles build up. I’ve done this very successfully.

EDIT: I was curious if any steel was being removed so I held a little pen magnet to the particles and absolutely nothing was attracted to the magnet.

Lead-fouled bores and chokes can destroy patterns.



.