Hope I'm not drawing this out too long so I appreciate everyone's patience. Questions I have are:
- I was going to take the sideplate apart to clean it. Is there anything I need to be careful about when disassembling it?
- I need a firing pin seat which I'll have to try and locate somewhere. Doesn't this also need some kind of a spring for the firing pins?
- One of the parts on the Numrich site was called a locking bolt. I'm not sure what it is or where it goes but it's a pretty good sized part that I don't see in my gun. Any thoughts? Would it happen to go in the round hole in the receive right in front of the safety rod?
Well this is a start and I'm sure I'll come up with some more questions as I go along.
Thanks again,
Kirk
Meriden
Hybrid Mode