Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
I have cleaned the finish from the fore end and I have identified a split in the knuckle end ear that I will have to close up before proceeding with checkering.
There is a small amount of oil in the wood at the knuckle end that I would like to extract as much as possible without discoloring the wood. Any and all suggestions welcome. I have removed oil on another project gun (Lefever) but in that case I was able to work with the entire fore end wood and not just one end.
Fore end cleaned with discovered split.
Threaded Mode