Pellet count vs. choke

[OH Osthaus]

As Dean says

Choke is based on a percentage of the shot in a 30” circle at 40 yards (except for .410 I think)

Pick a pellet size and load. Count the pellets in that load and then fire a few at a pattern board - count the holes in the circle and average it out

BTW. Different pellet sizes may pattern a just a little different in the same gun. So go with the load you will use

[Randy Roberts]

Keavin is this what you are seeking ? I seem to recall a similar chart in TPS as well concerning the choke percentage figures.

[Keavin Nelson]

Originally Posted by Randy G Roberts

Keavin is this what you are seeking ? I seem to recall a similar chart in TPS as well concerning the choke percentage figures.

Yes Randy, spot on, thanks. I will go to the TPS next

[Researcher]

Remington Arms Co. published these choke/pellet counts for 40%, 60% and 75% for 7/8, 1, 1 1/8, 1 1/4 and 1 1/2 ounce loads in their catalogs.

Choke Pellet Counts 40%, 60%, 75%, 1904-05 Remington Arms Co. Catalog.jpg

[Keavin Nelson]

Originally Posted by Dave Noreen

Remington Arms Co. published these choke/pellet counts for 40%, 60% and 75% for 7/8, 1, 1 1/8, 1 1/4 and 1 1/2 ounce loads in their catalogs.

Attachment 88083

Thanks Dave.

[David Noble]

[QUOTE=Dave Noreen;311628]Remington Arms Co. published these choke/pellet counts for 40%, 60% and 75% for 7/8, 1, 1 1/8, 1 1/4 and 1 1/2 ounce loads in their catalogs./QUOTE]




Did Remington state the circle size and distance?