Finally found a Philly Fox I like

[Double Lab]

Originally Posted by edgarspencer

It belongs to a friend. I didn’t go over to the dark side.

Trust me on this one my friend the dark side doesn't start with the initials A.H. but the intials L.C. come to mind.

[Researcher]

I need shells for the three toy guns I have accumulated.

The shells are harder to come by than the guns themselves. I'm fortunate that my three had the shells with them.

There are several variations of the Fox Play Gun. Most have a top-lever, but some just have a stud for a barrel lug that engages a spring clip in the receiver. Top-lever above, spring clip stud below --

IMG_0018.jpg

Some have a fixed hinge-pin and some have a spring-loaded hinge-pin which allows the gun to be taken down. The lower gun is a Fox Products Co. and it has the spring-loaded hinge-pin --

IMG_0016.JPG

Now just need a leg-of-mutton case for one.

These A.H. Fox Gun Co. ads both show the top-lever --

Fox Play Gun, December 1928.jpg

Fox Play Gun, August 1929.jpg

[edgarspencer]

Originally Posted by Daryl Corona

Trust me on this one my friend the dark side doesn't start with the initials A.H. but the intials L.C. come to mind.

Don’t let my serious demeanor fool you, Daryl. I was only joking.....a little.....kinda.

[Double Lab]

Originally Posted by edgarspencer

Don’t let my serious demeanor fool you, Daryl. I was only joking.....a little.....kinda.

Me too..... kinda.... sorta.

[mobirdhunter]

So the questions now: should the barrels be re-blued, the chambers lengthened, the stock refinished?? (And what about the chokes?!?)