Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
Dennis, do these photos look familiar? Note the steel filled epoxy added to fill the gap in the muzzle where the solder has a void, and the sloppy job on the front bead. I took a close up of the engraving at the breech too since you mentioned it. The left barrel also had noticeable upturn to it toward the end, somewhat like a banana. It was noticeable when I looked down the side of the tube. The right barrel curved slightly too, but not as much. The gun is now in a box... http:// http:// http:// http:// http://
Last edited by Garhart Stephenson; 03-06-2020 at 01:18 AM..
Threaded Mode