Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
The fact that Brian has a cocking lever without the hole and since the pivot hole and the cocking rod hole are all that is required to orient the part for machining the visible hole when assembled in the action must be for lubrication. I think the part is forged, the 2 shaft holes drilled in a drill jig, the part was then finished on a profiler, and the oil hole could have been added when the shaft holes were drilled or after profiling. I doubt the part required heat treating.
Threaded Mode