Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
In my opinion, it would be foolish to spend another dime on this gun. Any annealing will soften it, but it will erase any 'memory'. Annealing it would only soften it so that it could be mechanically manipulated, and that's a total black hole. I say this because I spent over 30 years making steel, then heat treating it. If a casting warped in heat treat, it was always possible to anneal, straighten, and re-heat treat. All luxuries I may have had are lost once a part is finish machined.
The Following 10 Users Say Thank You to edgarspencer For Your Post:
Threaded Mode