Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Drew, I don't make recommendations,too many attorneys but these are the minimums for me 2" .050, 2.5" .065, 2.75' ..070, and 3' magnum .080. Edgar, the axial shaft is the pivot point for the cocking levers and shares the same axis/center with the forearm iron.
Threaded Mode