Indexing of Screws
I have wondered if all screws, inside and out, were either 180 degrees or 90 degrees to the long or vertical axis of the gun when it was assembled at the factory. The obvious ones on the frame and floor plate are supposed to be like that. I have seen fore end iron with all screws at 180 but I have seen many at various angles. Were the two butt plate screws all at 180 to the vertical axis?
While hardly critical to function, it is aesthetically pleasing when all visible screws are at the 180 or 90. Was that how it was supposed to be ?? Did it matter for the non-visible screws or was Mr. P not that obsessive??
Slow night here.
Cheers,
Jack
__________________
Hunt ethically. Eat heartily.
|
Threaded Mode