With respect to the negative comments about Tru Oil, I have used it successfully for years to refinish stocks and also to refresh old finishes. I suspect that the negative comments may be because of the way it is used or the fact that it has to be thinned occasionally.
On refinished stocks, I wet sand the wood with Tung oil and then use my fingers to work the mud into the pores against the grain. I repeat the process, letting the mud dry fully, until all the pores are filled.
Then I rub a small amount of Tru Oil into the stock and wipe it down with an old clean T shirt. This leaves a very small amount of True Oil with each iteration. I re-do the process until I get the depth I am looking for.
I’ve never had a problem with Tru Oil. If used properly, it works well……in my opinion.
|
Threaded Mode