Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
Im guessing it would be a possible for an experienced gunsmith. I just had a set of 410 and 28 ejector barrels barrels fit to my 20 gauge by Bill Schwarz.
Of course the 20,28,and 410 all used the same frame. I would think you could fit the 16’s to a 20 gauge as you could strike the barrels to contour the bolsters.
Plenty of other guns have barrels fit up after deivery to make 2 gauge sets. Good possibility Winchester 21 is the same.
Threaded Mode