Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Anything is fixable at a cost. However, the right time to do that would have been before the barrels were finished. Repair now could drive up the repair cost a bit due to having to finish the barrels again. But I could think of a few methods that may avoid needing to refinish.
Threaded Mode