I made a tapered wood plug just the right size, it’s fixed to the end of a 1/4 rod. Spin it in the lathe or drill press it heats up the plastic and re forms like a fresh uncrimped hull. It’s a fair amount of trouble to cut down hulls, getting a few more loads out of them worth the little effort it takes to run the plug . It handles the skiving job too.
Use them for 16 & 10 were I am forced to use many Cheddite hulls. Ballistic products tool is tapered, one size fits all and not very effective in my opinion.
William
|
Threaded Mode