|
 |
 |
|||||||||||||||||||||||||||||||||||||
| ||||||||||||||||||||||||||||||||||||||
 |
 |
03-07-2017, 04:04 PM
|
#3 | ||||||
|
I have a top lever 10ga hammer gun #3 frame. What I am thinking of doing is using the plastic dog's head butt plate as a spacer behind a silvers #3 pad that I am going to be putting on this gun. The gun has a short LOP that is why I want to add to it. It currently has a non original metal buttplate with the spur on top and I just want to use something to fill in the spur on top of the butt when I add the silvers pad just so it looks cosmetically nicer. I am going to try and keep the end of the stock as is so I can put the metal buttplate back on in the future if need be.
|
||||||
|
|
||||||
 |
 |
 |
|
|
|
03-07-2017, 04:05 PM
|
#4 | ||||||
|
I will machine the plastic DHBP so it sits flat against the Silvers pad.
|
||||||
|
|
|
||||||
|
|
|
|
|
|
03-07-2017, 04:19 PM
|
#5 | ||||||
|
I thought there was a Silvers pad with the spur or maybe it was a copy of the Silvers. You might want to do a little searching
|
||||||
|
|
|
||||||
|
|
|
|
|
|
03-07-2017, 04:46 PM
|
#6 | ||||||
|
Brian Dudley had replied to a previous thread saying that the CSMC pad that had the spur, the spur was too small to fit properly. I don't know if there are any other pads with a proper size spur??
|
||||||
|
|
|
||||||
|
|
|
|
|
|
03-07-2017, 04:48 PM
|
#7 | ||||||
|
Silvers pad spurs are much smaller than the spurs on Parker buttplates.
To answer the original question, Spurred dogs head buttplates come in 6 different sizes as I can figure. 4 of which are most commonly found and are being reproduced these days. Most 10g. guns used the number 3 size which is being reproduced by a few sources. I stock this size plate, along with most others.
__________________
B. Dudley |
||||||
|
|
|
||||||
|
|
|
|
|
|
03-07-2017, 06:04 PM
|
#8 | ||||||
|
Bob have you considered using a piece of wood for the spacer? You could fit it to the stock and maybe even treat it to match then add the pad.
__________________
There is no hunting like the hunting of man, and those who have hunted armed men long enough and liked it, never care for anything else thereafter...Earnest Hemingway |
||||||
|
|
|
||||||
|
|
|
|
|
|
03-08-2017, 02:35 PM
|
#9 | ||||||
|
Does anyone know if someone makes a thin spacer that is radiused on one side to fit the existing butt stock curvature but it is flat on the opposite side to go against the rubber pad?
|
||||||
|
|
|
||||||
|
|
|
|
|
|
03-08-2017, 05:40 PM
|
#10 | ||||||
|
Most plastic spacers (and silvers pads for that matter) will flex to a curve. Sometimes it takes boiling water or a heat gun to make it happen.
__________________
B. Dudley |
||||||
|
|
|
||||||
|
|
|
 |
|
|
Linear Mode
