After 2or3 reloadings the Federal and Cheddit hulls I have been using start to split in the crimp. So, I tried trimming the hulls to 2 3/8 inches, use the same shot and powder load as with the 2 7/8 inch and trim the wad 1/4 inch with sizzors and don't use the 1/2 inch filler wad in the shot cup. Raise the short adapter on the MEC 600 jr up another 1/2 inch and it crimps perfect. Tried them on the crony and patterning board and see no difference. Loaded it is a neet looking 2 inch shell and you get 2 or 3 more loadings out of the hull and don't have to buy or use filler wads. Carvel
|
07-28-2016, 04:55 PM
Short 10
Hybrid Mode