Brian, I believe finding a set of original extractors would be improbable.
It would not be too difficult to make a set or have them made. As best as I can remember they are square where they bend up into the extractor cuts of the barrel and then filed triangular where they run under the barrels. The short studs in the barrel flats were just swaged over to retain them.
Value? That's subjective. As a general rule these are collector pieces and not shooters.
They are in a sense the Colt Pattersons of Parker sxs's. In an auction like Julia's, a fine example that was presented well and "talked up" could go for a good bit!
I thought I did fairly well when I sold mine about 12 years ago for $1750 but I have regretted selling it ever since.
|
Threaded Mode