Member for about as year.

[Bill Crowden]

Originally Posted by Dave Suponski

Bill,Contact Bob Fulton at Stock Fixers I have seen them do some wonderfull work on stocks that for lack of a better word were "Junk" stocks@ruralfree.net or 1-307-436-5561

I actually started this process by sending my stock to Mr. Fulton, he did say he was busy and it was my oversite not to ask just how busy is busy until after I had sent the stock off to WY. Well Mr. Fulton is VERY busy, like an 11 month waiting list and since this is going to be my only shotgun I couldn't wait past hunting season. Dave Wolf is very skilled and a true perfectionist I just don't know that I am ready to invest another $2750 in a gun I already have $2000 in, so I have been looking at every option. One I am considering is bidding on a Turkish Walnut stock from huntersbid.com and then having it machine inlet using my broken stock as a model and then giving that to Mr. Wolf to fit and finish---opinions, thoughts, recommendations for a source to machine inlet or advise.

[Opening Day]

You can do that but it is very expensive and it is going to take min. of six month and probably a year. So the timing is going to be about the same. There is a man in Michigan that could do the repair work, quite a few members have used him and is turn around time is six weeks to two months. His name is Ehgarb and his phone is 248-446-9927 might not hurt to give him a call

[Bill Crowden]

Originally Posted by Eric Eis

You can do that but it is very expensive and it is going to take min. of six month and probably a year. So the timing is going to be about the same. There is a man in Michigan that could do the repair work, quite a few members have used him and is turn around time is six weeks to two months. His name is Ehgarb and his phone is 248-446-9927 might not hurt to give him a call

Thanks Eric I will give him a call. Bill