The best all around powder ?

[J.B. Books]

Originally Posted by chris dawe

Sorry should have said that ,I load for 10,12,16,20.

I don't think there is a perfect all around powder for those 4 gauges.

If I had to stick to one powder Green Dot would be my first choice, 700-X second choice.

GD works well with 1 1/8 and 1 1/4 10ga, 1 and 1/8 ounce 12ga. In 10 and 12ga it provides both velocity, payload and lower pressures. It does OK with 3/4 and 7/8 ounce 16ga and 3/4 ounce 20ga but pressures are high in both these gauges.

There were some older published loads for 700-X that have been taken out of print. Published loads today have pressures with 700-X in 20ga are at the max 11-12K with Federal hulls only.

[chris dawe]

Thanks for all the help ,it go's to show on this forum ...all we have to do is ask

I load the ten to 1 3/8
twelve to 1 1/8
sixteen to 1
the twenty I haven't started yet ,.but was thinking 3/4 -7/8

these would be hunting loads,I like to keep them below 9000 psi ,the ten is no tox

I fear my batch of 4756 will run out this season ,so I was proactively thinking of a replacement,

[6pt-Sika]

At the moment I use SR7625 for the Short 10 , 12 , 16 and 20 .

Now after the 10 pounds I have is used up I have no idea what I'm going to !

[Snap Cap]

Chris, your real thorn in this mix is the nontox 10 load. What hull length and type of shot (steel, Bismuth, Nice, ITX, TM, rock salt, rubber buck shot)? Loads meeting your criterion for the other 4 gauges (assuming lead shot and velocities don't need to be > than 1250 fps) can all be loaded a single powder.

[chris dawe]

I use bismuth ,and lead

[Snap Cap]

Chris, is the Bismuth 10ga. load you need for a 2 7/8" hull or a 3" or longer hull?

[chris dawe]

I load for both 2 5/8 and 2 7/8

[Snap Cap]

Originally Posted by chris dawe

Thanks for all the help ,it go's to show on this forum ...all we have to do is ask

I load the ten to 1 3/8
twelve to 1 1/8
sixteen to 1
the twenty I haven't started yet ,.but was thinking 3/4 -7/8

these would be hunting loads,I like to keep them below 9000 psi ,the ten is no tox

I fear my batch of 4756 will run out this season ,so I was proactively thinking of a replacement,

Bill M. could you share your recipe using Unique powder for a 2 5/8' 10ga. 1 3/8oz. Bismuth load making less than 9000 psi and its velocity?


Paul could you share your recipe using Green Dot powder for a 2 5/8' 10ga. 1 3/8oz. Bismuth load making less than 9000 psi and its velocity?

I have been looking for more 10 ga. 2 5/8 non tox load data too. Thanks.