Quote:
Originally Posted by Jerry Harlow
I've seen all the debate about 2 3/4" shells in 2 1/2" or 2 5/8" chambers which I shoot all the time, but do you believe the same applies to the short 10? I picked up a lifter 10 on a No. 2 frame with Plain Twist but it has 2 5/8" chambers. All of my shells are 2 7/8" with about 7700 p.s.i. according to the chart. Shooting 1.5 ounces which I like. I know I could roll crimp but I've never had success with that and don't know of a 1/4" spacer for the 10 short kit.
Opinions? Thanks.
|
I'll get a picture for you- I put a 1/4 riser under my MEC 10's short kit, just a scrap of maple plywood I had around- just traced the shell holder and cut it out on the band saw- works fine
but lately I have been using the Ballistic Products roll crimper- i like the results,
Threaded Mode