Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
Elmer Keith was a heavy load fan, but he speaks quite glowingly of the traditional 1 1/4 ounce ten ga load in his book. Although you may not see any metal problems with heavier loads, watch for a little chip forming in the wrist of the stock behind the top tang of the frame, or a widening of the inlet gap around the tang.
Is your 3 frame gun stamped NH or PH on the water table?
10 Ga Loads
Threaded Mode